Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

In this episode, Liu Yi basically explained to everyone action of cutting ball without turning glue.

Click me to watch a tutorial video on right hand cutting and no turning

Click me to watch tutorial video on right and no rotation

Reverse chipping rubber can cut ball with or without spin. This is also key to winning chip. There are differences, essence of action of cutting a non-rotating ball with reverse glue is as follows. .

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

1. Point of impact

When ball is not spinning, point of impact should be as low as possible under table so that camouflage is better and it is more difficult for opponent to judge spin of ball.

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

Two, point of contact

The point of contact is point above head of racquet, that is, outside sweet spot and close to edge of board.

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

Third, direction of force

To carve a non-spinning ball is to touch it, press down from top of racquet head, and tap again to stop ball from spinning.

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

Fourth, fake action

In order to better confuse opponent during game, you can use some kind of false movement, such as stamping your feet, etc., then this is a false move that gives opponent feeling that ball is being cut, but in fact it's not a spin of ball.

We have already explained basics of action of hooking ball with and without ball, let's look at difference between two points of impact.

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

One, sharp

(1) Point of impact

When hooking, do not put it under table. If you do, it will be very slow and high because opponent is pulling and turning, so hit point should be a little higher and then you do a sweep and rub a little.

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

(2) Trick

When cutting ball, you must use your power covertly, and if you don't show it, you will feel like you didn't use power to confuse your opponent and make him make a mistake.

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

Second, cutting cannot rotate

(1) Point of impact

When hitting a non-spinning ball, try to put point of impact below table to break off because opponent is pulling very hard, put point of impact lower when hitting ball, press down and push forward, it is very hidden so that opponent does not see, it is very important.

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

(2) Trick

When ball is not spinning, action can be made more obvious and exaggerated, such as some feints like stomping that make people feel like they are going to hit ball very hard when they really aren't. use a lot of force, which causes opponent to err in judgment.

Master skill of cutting ball with fake movements, right hand not only cuts off different rotations, but also confuses opponent

This is end of this lesson. If you think it's good, add it to your collection. If you have any questions about table tennis technology, please leave us a message in questions section of Pingpong.com. We have professional trainers to answer your questions in shortest possible time.

Ping-pong network organized by Liu Baosheng


October 06, 2023