When cutting ball with a long rubber and a reverse rubber, these two characteristics are different. Understand this strategy and handle long rubber easily.

When cutting ball with a long rubber and a reverse rubber, these two characteristics are different. Understand this strategy and handle long rubber easily.

Click on me to watch video tutorial

Today we will answer questions from these two players from Pingpong.com:

1.Wet FatherHello, I've always been confused about chop ball rotation. Is it a reverse rubber or a long rubber? Spin, I often can't get ball my opponent cuts with backhand, can you talk about their spin?

When cutting ball with a long rubber and a reverse rubber, these two characteristics are different. Understand this strategy and handle long rubber easily.

(1) The chipping characteristics of back glue and long glue are different

The first thing to understand is that adhesive-backed cutting ball needs to rotate more than long rubber cutting edge. The long rubber cutting edge is usually placed on back of hand while chopping. This is mainly for spin control, because if ball is pulled by the opponent, it is more aggressive. It is difficult to cut, so chops usually have a long backhand (or rough backhand) and then use a forehand to attack (grab or snatch) and a backhand to control spin.

When cutting ball with a long rubber and a reverse rubber, these two characteristics are different. Understand this strategy and handle long rubber easily.

(2) Grinding characteristics of granulated rubber

A grainy rubber player will not spin much when chipping a ball pulled by an opponent, but will change spin of ball. , chipped ball will sink a little.

When cutting ball with a long rubber and a reverse rubber, these two characteristics are different. Understand this strategy and handle long rubber easily.

(3) Strategies for controlling crumbling granules

When you're fighting a rubber grinder, you have to pay attention to an accurate spin estimate. If an opponent is using reverse rubber to chip away, more you spin, more spin ball he slices will spin. At this time, do not forcibly pull, you can try to operate briefly, just wipe board.

When cutting ball with a long rubber and a reverse rubber, these two characteristics are different. Understand this strategy and handle long rubber easily.

Second, what problems does this golfer have with playing moves?

(1) Issues

1. Too much pressure on face

This golfer is hitting horizontally with his racket. While playing, face of racket is pressed hard, mostly at a 40–30 degree angle, and then whole wrist is swayed hard.

2. Fingers not holding onto racket surface

He couldn't get up to shoot at all. Although effect of video was not good, it can be seen that it has problems with capture. The three fingers at back did not support shot. The thumb and forefinger are tightly connected, and fingers behind it are loosely closed. They are covered and flap, and then wrist is still swinging during entire process of hitting. The surface of racket is getting lower and lower, and control arc is very bad.

When cutting ball with a long rubber and a reverse rubber, these two characteristics are different. Understand this strategy and handle long rubber easily.

(2) Solution

1. The shooting surface must be maintained at a temperature of about 65 degrees

Adjust your grip and hold surface of racket at an angle of about 65 degrees.

When cutting ball with a long rubber and a reverse rubber, these two characteristics are different. Understand this strategy and handle long rubber easily.

2. Fingers should support surface

Three fingers at back should support surface of racket, which is good for controlling trajectory of strike.

When cutting ball with a long rubber and a reverse rubber, these two characteristics are different. Understand this strategy and handle long rubber easily.

Ping-pong network organized by Liu Baosheng


December 03, 2023